Bf-109 F2, 4./JG54, Oblt. Hans "Phips" Philipp

Finish the engine: high-to-wire bus to candles, imitation candles, oil pressure system and circulation pipes, rods throttle, starter, transport loops, wiring and much more.
   When assembling the cockpit used photoetching Eduard, plyussamodelnye Revised: various wiring, rods, tubing fuel drop tanks and other trifles. The instrument panel is also from Eduard, plus minor changes sight - filter, wiring.
   Pilot's seat was different from the standard seat-mounted versions F and looked like a chair Series E. The chair was redone with dkuhkomponentnoy Tamiya putty and foil.
   In order to revive the model, it was decided to open the hatch in the fuselage to the radio, which was cut and in its place installed aluminum, made a power set, radio, wiring and some of what traction.
  Made light cabin. Just one section left open on the left wing, throwing back a couple of wires and rods.
   Hoods ground off the inside half, made of thin copper Piano hinges and restored power set, the cook brought to the corresponding geometry, before the first branch pipes drilled holes and punch made by the working rudders and height, replaced by aluminum (stronger) tail mount antenna made workers resin ailerons from Quickboost, flaps (which is made from the ends imitation shell plates) and the slats on the wings made mooring rings. Radiator Scoops also made workers also made a double top plate, between which are set stringers.
   Drilled drainage holes in the fuselage and cowl oil tank, made to pull flaps radiators.
   Have a working medium (flip) the part of the lantern, carved handles for sliding panes, the left of which also made the work. On the upper pane made opening handle to the right port with an imitation pistol shell plate well, and a rope-swing limiter canopy. The front of the light (visor) simulated rotary window.
    
   Chassis: rubber was used by El, and only the tires, because the drives they have absolutely no authenticity. Drives the wheels of a sawed off "Zvezda", except for the drive crutch, which because of their microscopic quite tolerable. Crutch brazed aluminum wheel is spinning on it, which is not the other wheels, since they had to stick a tube hydraulics. On the landing gear made technical line, with unnecessary decals suitable size.
    
   Did the other small parts, Pitot tube, tail ELN expanded-transparent gate, antenna monofilament, radomes for all the known technology, the hook on the antenna mast and the other stuff you can not remember already.
    
   Standard coloring: RLM 74/75/76 colors Akan, ModelMaster and Tamiya, enamel remover again Tamiya, pigments MasterPigment.