| Start of Weber carb master in bronze and brass. |
|
|
| Next I added the bowl to it. Since the bronze needed far more heat to fuse other parts to it using solder than the brass, I opted to use styrene for these parts. |
|
|
| Looks kind of like Wall-E… |
|
|
|
| This is the start of the top of the carb. |
|
|
| The base flanges have been added, they are made from acid cut brass from artwork I drew. |
|
|
| I also added the intake side flanges. |
|
|
|
| This is the beginning of the intake manifold. It is all brass soldered together. Mounting surfaces are acid cut and the tubes are just K&S stock cut and machined to fit. |
|
|
| This is the carb master and manifold dry fitted to the head. |
|
|
| I am close to being done with the master for the Weber carbs. There’s about 60 pieces to make this part, maybe a few more… The hardware will machined for each individual carb after I cast copies. |
|
|
|